You need to set the front speakers to large and sub to none in the speaker setup of the receiver. Now you would take a third RCA cable and connect the high pass out of the crossover to the pre ins of the Yamaha. If the sub is not a powered sub then your should connect it to the front left and right speaker connections along with the front speakers. If one of your subwoofers has both an RCA Line-in and Line out connection option, you can connect your home theater receivers subwoofer pre-out to your subwoofers line in and then connect the. This time you would throw the switch to break the link between the pre outs and the pre ins. If your home theater receiver has two subwoofer outputs, connect one of the outputs to one subwoofer and the second one to the other subwoofer. With a second RCA cable you would connect the low pass out to the sub. In this case you would connect the preouts to the line in of the crossover. Now it will not be possible for you to off load the bass from your main speakers unless you buy an electronic crossover. Now adjust the phase control until it sounds best to you and adjust for maximum output at a given volume setting. After connecting to the Yamaha CR1020 with a pair of speaker wire I am experiencing sub woofer hum in the Pioneer SW-8MK2. This is the Pioneer SP-PK52FS 5.1 system and the sub woofer has high level inputs. If you need further assistance give me the exact models of your speakers and sub. Now advance the volume on the sub until you have the balance you desire. So the new plan is to switch the new Klipsch speaker system with the speakers I have connected to the HT system. You can hook your sub directly up to the RX and then hook your monitors up to the subs thruputs. You did not say what model you have, so you will have to look at the spec sheet. Now set the crossover on the sub to the F3 point of your speakers X 2 for starters. You can do this, but unless you buy an electronic crossover you will have limited bass management, as your sub has no high pass out.Ĭonnect one end to both the pre outs on the Yamaha, and the other end to the two line ins on the sub.ĭo not throw the switch on the Yamaha to break the connection between the pre outs and pre ins. Click to expand.I would have thought it would have been sensible to sort this out before you bought the speakers and sub.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |